Hi Heinz,
This line of code is to wait until the CAN module is available. If your main is empty, I am not sure if the last piece of code executed.
In each DAVE v4 APP, there is a USAGE section in the APP Help documentation. For the CAN_NODE APP, the example is for CAN communication in loopback mode. Can you try it out to see if this is working on your setup?
Regards,
Daryl
This line of code is to wait until the CAN module is available. If your main is empty, I am not sure if the last piece of code executed.
In each DAVE v4 APP, there is a USAGE section in the APP Help documentation. For the CAN_NODE APP, the example is for CAN communication in loopback mode. Can you try it out to see if this is working on your setup?
Regards,
Daryl