To anyone wondering, it happens to me when i'm using the Serial Wire debugger instead of the JTAG one, and i power OFF and then ON again the board.
The code starts running even if the debugger is still connected, and when i go into debug session it doesn't program the flash memory.
Solution I found is to unplug, then plug again the debugger while the board is OFF, then power on the board. The code doesn't autostart so I'm able to debug with no issues.
Hope this is helping someone.
The code starts running even if the debugger is still connected, and when i go into debug session it doesn't program the flash memory.
Solution I found is to unplug, then plug again the debugger while the board is OFF, then power on the board. The code doesn't autostart so I'm able to debug with no issues.
Hope this is helping someone.