Hello Daryl,
I am using xmc1300 boot kit to program uC on target board. The board is in mass production , so , no hardware after thoughts.
In DAVE I switched to user productive mode.(Get BMI, Set BMI)
XMC1000_BmiInstallationReq(0xFFC0) was run in firmware to switch back to ASC mode.
I cannnot read BMI using Get BMI in DAVE.
I am actually using using SWD1(P1.3,P1.2) for programming flash.
Do I use XMC1000_BmiInstallationReq function to switch back to SWD1 instead of ASC mode?
I could do that and waste a uC.:)
regards
AAH
I am using xmc1300 boot kit to program uC on target board. The board is in mass production , so , no hardware after thoughts.
In DAVE I switched to user productive mode.(Get BMI, Set BMI)
XMC1000_BmiInstallationReq(0xFFC0) was run in firmware to switch back to ASC mode.
I cannnot read BMI using Get BMI in DAVE.
I am actually using using SWD1(P1.3,P1.2) for programming flash.
Do I use XMC1000_BmiInstallationReq function to switch back to SWD1 instead of ASC mode?
I could do that and waste a uC.:)
regards
AAH