XMC1302 Kit -> CCU8 Trap???

Hi~
There are questions about the CCU8 Trap.
Configuration are as follows:

Attachment 2111
<General settings>
- edge aligned
- asymmetric
<external event setting>
- CCU8 event0 - start
- CCU8 event2 - Trap
<Timer event setting>
- Compare2 match while counting up
- event2

The PWM waveform is output when the external pin to start CCU8 and Compare2 match while counting up
event occurs and interrupt
At this time,
If a different external pin to give a signal to the trap event2 pwm output does not go.
But compare2 event interrupt and is still occur

Are there any other event that can not operate when the trap work?

Attached Images

• 1.JPG‎ (46.6 KB)