Can Driver Configuration Issue

Hello All,

I am configuring Aurix 38x CAN driver with one Diagnostic physical message (Tx and Rx messages)which is configured through CANTP, PDUR and DCM. When I am sending the message using IG block (Rx message to ECU), ECU is not responding with ACK.

Now, I checked the CAN registers, I observed CAN0_ACCEN0 has "FFFFFFFF" value.

Debug information: Can_Status is in Initialized state ('4').

Can you please suggest for missing configuration.

Thanks in advance.Attachment 4399Attachment 4399

?????

• CAN_Driver_Configuration_1Mbps.docx‎ (162.8 KB)