Hi Bernie,
In ASCLIN ASC mode (UART) ,we have standard ASC and High speed ASC mode for transmitting data at higher baud rates. For high speed ASC mode, we require Rx and Tx but also CTS and RTS signals i.e handshaking signals.
You can read further in chapter 18 (ASCLIN ) of user manual. And be careful while pin selection i.e. look out for shield buddy user manual.
Regards,
Neeraj
In ASCLIN ASC mode (UART) ,we have standard ASC and High speed ASC mode for transmitting data at higher baud rates. For high speed ASC mode, we require Rx and Tx but also CTS and RTS signals i.e handshaking signals.
You can read further in chapter 18 (ASCLIN ) of user manual. And be careful while pin selection i.e. look out for shield buddy user manual.
Regards,
Neeraj