Is there any way user can run HSM Core from TriCore for Aurix 2G?

UCB_HSMCOTP0/1_ORIG and UCB_HSMCOTP0/1_COPY is related to HSM enabling/disabling

The SSW(Start up Software) boots the HSM module (i.e. HSM executes its firmware) when the field DMU_SP_PROCONHSMCFG.HSMBOOTEN is set.
Field : HSMBOOTEN
0 - HSM Boot is not enabled
1 - HSM Boot is enabled

In case of enabled HSM, SSW check below 3 contents
– check if ECC error occurred
– check that stack pointer points into internal RAM
– check that reset vector points into a valid HSM PFlash sector (sector HSM0X to HSM39X).

If there is no valid code in HSM PFlash sectors, MCU will be locked. at that time, there is no recovery method.

So, user have to program valid HSM code in HSM PFlash sectors. And then, user have to enable HSM