Can you please clarify if following will be the TLF35584 device behaviour when MCU is goes through below scenarion
1. MCU comes out of Reset
2. MCU initializes SBC registers & enables watchdog & error monitoring (Proper Initialization of SBC)
3. MCU send SBC SPI: Go to NORMAL command --> At this point SBC is in Normal mode
4. MCU crashes/resets due to error in MCU's application SW
- After Step#4, will TLF35584 device be in Normal Mode or go to Init (will SBC observe MCU going through a reset and move to Init) ?
- After Step#4, will TLF35584 device move to FailSafe State as error monitoring signal goes low due to MCU reset ?
1. MCU comes out of Reset
2. MCU initializes SBC registers & enables watchdog & error monitoring (Proper Initialization of SBC)
3. MCU send SBC SPI: Go to NORMAL command --> At this point SBC is in Normal mode
4. MCU crashes/resets due to error in MCU's application SW
- After Step#4, will TLF35584 device be in Normal Mode or go to Init (will SBC observe MCU going through a reset and move to Init) ?
- After Step#4, will TLF35584 device move to FailSafe State as error monitoring signal goes low due to MCU reset ?