Hi!
I also have the same problem. I need to bring the PWM outputs into a safe condition.
Read the GCTRL.SUSCFG documentation below
Suspend Mode Configuration
This field controls the entry in suspend mode for all the CCU8 slices.
00B Suspend request ignored. The module neverenters in suspend
01B Stops all the running slices immediately. Safe stop is not applied.
10B Stops the block immediately and clamps all the outputs to PASSIVE state. Safe stop is applied.
11B Waits for the roll over of each slice to stop and clamp the slices outputs. Safe stop is applied.
Setting 10B or 11B can not get the desired result.
Are there other settings to do?
If you have any idea of that
Thanks in advance
regards
Stefano
I also have the same problem. I need to bring the PWM outputs into a safe condition.
Read the GCTRL.SUSCFG documentation below
Suspend Mode Configuration
This field controls the entry in suspend mode for all the CCU8 slices.
00B Suspend request ignored. The module neverenters in suspend
01B Stops all the running slices immediately. Safe stop is not applied.
10B Stops the block immediately and clamps all the outputs to PASSIVE state. Safe stop is applied.
11B Waits for the roll over of each slice to stop and clamp the slices outputs. Safe stop is applied.
Setting 10B or 11B can not get the desired result.
Are there other settings to do?
If you have any idea of that
Thanks in advance
regards
Stefano