Thanks God. Someone is there who answers in the forum. I has lost all hope from this Forum. Thanks M.K. for answering.
After so many days I checked the forum and I am answering right now.
I have checked the Errata section in the user manual.
And I had already found out
9.2 Jumper (JP6) not connected to VDDP And I did the work around.
9.1 Short of internal layer 2 and Jumper (JP4). But i have nothing to do with as I am not using VDDEXT.
I have 2 nos of TLE9879 Eval Kit .But my problem remains at BRDV is not switching On in both Boards.
1) We have checked the MOSFETs & Measured: (Drain-Source, Gate-Source, Gate-Drain) there are no shorts. (100% sure)
2) For Board No. 1, VCP is low(5V) and Board No. 2, VCP is OK.(>12V)
3) Clear Interrupt Status Flags: Did SCUPM->BDRV_ISCLR.reg (TLE9879 User Manual rev1.3 Page: 198) (Screenshot attached for Board No. 1 )
Attachment 3269
Board No 1 shows supply error.
And for Board No. 2, doesn't show any error. But when I switch on the bridge drive(Brdv_Set_Bridge(xx,xx,xx,xx,xx,xx)) all MOSFET show over current error.(I will provide the screenshot when available).
4) I am not sure. But i am able to program both of the boards all peripherals(GPIO, ADC, PWM, UART etc.) except BRDV.
Reg
sourav
017627755601
After so many days I checked the forum and I am answering right now.
I have checked the Errata section in the user manual.
And I had already found out
9.2 Jumper (JP6) not connected to VDDP And I did the work around.
9.1 Short of internal layer 2 and Jumper (JP4). But i have nothing to do with as I am not using VDDEXT.
I have 2 nos of TLE9879 Eval Kit .But my problem remains at BRDV is not switching On in both Boards.
1) We have checked the MOSFETs & Measured: (Drain-Source, Gate-Source, Gate-Drain) there are no shorts. (100% sure)
2) For Board No. 1, VCP is low(5V) and Board No. 2, VCP is OK.(>12V)
3) Clear Interrupt Status Flags: Did SCUPM->BDRV_ISCLR.reg (TLE9879 User Manual rev1.3 Page: 198) (Screenshot attached for Board No. 1 )
Attachment 3269
Board No 1 shows supply error.
And for Board No. 2, doesn't show any error. But when I switch on the bridge drive(Brdv_Set_Bridge(xx,xx,xx,xx,xx,xx)) all MOSFET show over current error.(I will provide the screenshot when available).
4) I am not sure. But i am able to program both of the boards all peripherals(GPIO, ADC, PWM, UART etc.) except BRDV.
Reg
sourav
017627755601