Dear all,
In tle987 Eval Kit, I generate PWM using CCU6 and check the output in the Pins P0.x & P1.x and it functions Ok.
But when allow the PWM to connect with Bridge Drive(BRDV), I do not see any PWM at MOSFET gates.
For this, I have the following program where I wanted to check the PWM at GH1(High side MOSFET1) and it is not available but at Pin 0.4 it is available.
checking the GH1 with an oscilloscope
Attachment 3270
Screen shot in debug mode
Attachment 3271
please find the code here
https://drive.google.com/drive/u/1/f...WxsMmVxakdvcms
Reg
sourav
In tle987 Eval Kit, I generate PWM using CCU6 and check the output in the Pins P0.x & P1.x and it functions Ok.
But when allow the PWM to connect with Bridge Drive(BRDV), I do not see any PWM at MOSFET gates.
For this, I have the following program where I wanted to check the PWM at GH1(High side MOSFET1) and it is not available but at Pin 0.4 it is available.
checking the GH1 with an oscilloscope
Attachment 3270
Screen shot in debug mode
Attachment 3271
please find the code here
https://drive.google.com/drive/u/1/f...WxsMmVxakdvcms
Reg
sourav