TC223 Starter Kit UART over DAP

HI All,

I trying to find out if it's possible to have UART over DAP (external miniWiggler connected to board DAP port) in same way as it's achieved with on board miniWiggler.
To be precise I want ot achieve setup on which I can communicate with board over virtual COM port provided by miniWiggler device (external).
I can use on board miniWiggler in such configuration without problems but I have to switch to external one (connected via DAP port).

Did anyone tired to configure UART over DAP for TriCore Starter Kit boards? Is this even possible?

Best Regards,
Konrad