Hello,
I´m trying to send a command (string = LED_ON) with HTerm to switch on/off a LED.
Is this possible with the Pin0.14 and Pin0.15 at the XMC1100 Boot Kit ?
I´m looking for a solution for changing the BMI back to ASC_BSL mode when receiving a special command via UART.
So hopefully it is possible to change the BMI with a command with using the Pin0.14/Pin0.15.
Is there somewhere an example ?
I´m trying to send a command (string = LED_ON) with HTerm to switch on/off a LED.
Is this possible with the Pin0.14 and Pin0.15 at the XMC1100 Boot Kit ?
I´m looking for a solution for changing the BMI back to ASC_BSL mode when receiving a special command via UART.
So hopefully it is possible to change the BMI with a command with using the Pin0.14/Pin0.15.
Is there somewhere an example ?