Quote:
Originally Posted by electronwrangler
![View Post]()
Hello, I am trying to connect to the IMC101T-T038 on my custom board using the IMOTION-LINK debug probe and am getting an error that says "MCEDesigner cannot connect to target device!" My computer recognizes the debug probe as COM5. Here is what I've done so far to try and solve the problem.
- Change Connection (under Preferences) to Connect using COM5.
- Verified continuity between debug probe connector and chip pin
- Verified correct pinout of connector on custom board. It is the same pinout as what's shown in Figure 2 in the Imotion User manual
- Tested with another board to verify that its not an assembly problem or that the chip is damaged
- Ensured chip is getting 3.3V power at pins 10 and 26 with respect to pins 9 and 25.
Any help or suggestions would be greatly appreciated. Thanks!
- Change Connection (under Preferences) to Connect using COM5.
- Verified continuity between debug probe connector and chip pin
- Verified correct pinout of connector on custom board. It is the same pinout as what's shown in Figure 2 in the Imotion User manual
- Tested with another board to verify that its not an assembly problem or that the chip is damaged
- Ensured chip is getting 3.3V power at pins 10 and 26 with respect to pins 9 and 25.
Any help or suggestions would be greatly appreciated. Thanks!