Hi Bernie,
i'm having the same issue on TC2x7 application kit; i've downloaded the example project Blinky_LED_1_KIT_TC265_TFT; i've used an example project for TC265 because there are no example project for TC267, probably this is the cause of the issue.
Anyway the download went fine, everything was working until i've switched off/on the board, since then it is stuck keeping resetting every 2 seconds.
The watchdogs you're referring to are those already disabled in all example project?
In order to restore the board i'd like to try the hardware solution (since i can no longer connect with any software), but looking at my board i see i do not have R128, while i have R127... using an oscilloscope i see a 5V supply on pin TM for about 2 seconds, then it goes to 0 for less than a second, then again to 5V and so on...
Is there something i can do to restore the board?
Thanks,
Miglio
i'm having the same issue on TC2x7 application kit; i've downloaded the example project Blinky_LED_1_KIT_TC265_TFT; i've used an example project for TC265 because there are no example project for TC267, probably this is the cause of the issue.
Anyway the download went fine, everything was working until i've switched off/on the board, since then it is stuck keeping resetting every 2 seconds.
The watchdogs you're referring to are those already disabled in all example project?
In order to restore the board i'd like to try the hardware solution (since i can no longer connect with any software), but looking at my board i see i do not have R128, while i have R127... using an oscilloscope i see a 5V supply on pin TM for about 2 seconds, then it goes to 0 for less than a second, then again to 5V and so on...
Is there something i can do to restore the board?
Thanks,
Miglio